Mechanical Engineering

First Year

Second Year

Third Year

• Mechanical Engineering Core Module, Credit Hours: 6
  (See footnote 2 below)
• Mechanical Engineering Core Module, Credit Hours: 6
  (See footnote 2 below)
• Hum. or Soc. Sci. Elective, Credit Hours: 4
• Professional Development II, Credit Hours: 2
  (See footnote 3 below)

• ENGR 2350 - Embedded Control Credit Hours: 4
• ENGR 2600 - Modeling and Analysis of Uncertainty Credit Hours: 3
• ENGR 4300 - Electronic Instrumentation Credit Hours: 4
• MANE 4050 - Modeling and Control of Dynamic Systems Credit Hours: 4

• (See footnote 4 below)

Fourth Year

• Technical Elective (Restricted) Credit Hours: 3
• Technical Elective (Restricted) Credit Hours: 3
• Technical Elective Credit Hours: 3
• Hum. or Soc. Sci. Elective Credit Hours: 4
• Free Elective Credit Hours: 4
  Free Elective Credit Hours: 4
• Free Elective Credit Hours: 4

• ENGR 4010 - Professional Development III Credit Hours: 1

• (See footnote 5 below)

• MANE 4260 - Design of Mechanical Systems Credit Hours: 3

Technical Electives

Technical Electives

• The Technical Electives shall be comprised of three courses.
• Two of the three Technical Electives must be taken from any upper-level (4000 or above) MANE course.
• The third course may be selected from any upper-level (4000 or above) course in the School of Engineering or the School of Science.  An independent study course, such as a design project or an undergraduate research project in the School of Engineering or the School of Science may also be used to satisy this requirement.
• Technical Electives may not be taken on a Pass/No Credit basis.

Humanities or Social Sciences Electives

In this area, the electives are based on the Institute and School of Engineering requirements. Students are urged to elect humanities and social science sequences through which they will obtain adequate breadth and depth in subject areas. Students desiring minors in Humanities, Arts, and Social Sciences must consult the school or department in which the courses are offered to obtain further information and specific requirements.

Footnotes

1. These required courses may be taken in any order.
2. Choice of Mechanical Design Module and Thermal and Fluids Module. Both modules are required for graduation; each module may be taken in either semester.  The Mechanical Design Module consists of MANE 4030 and MANE 4040 taken concurrently. The Thermal and Fluids Module consists of MANE 4010 and MANE 4020 taken concurrently. Other third year courses may be taken in either semester.
3. This course will be fulfilled from a list published at the start of the semester. It must be completed before MANE 4260.
4. Course may be taken either semester.
5. Can be taken either semester senior year.
6. MATH 2010 and MATH 2400 may be taken in either semester of the second year.